Please enable / Bitte aktiviere JavaScript!
Veuillez activer / Por favor activa el Javascript![ ? ]
Programmer from Arduino to reset the cartridge chips - bug-code.com Q&A

Programmer from Arduino to reset the cartridge chips

0 like 0 dislike
101 views
There color laser printer Xerox Phaser 6125N after cartridge is empty, bought about this set for refueling. Tucked in, replaced the chip, nprinter does not define the cartridge — writes something like that which doesn't fit the cartridge, do not remember, long ago it was. Chips can say the same outwardly(left original, right the Chinese).
image
Then the problem is most likely in the firmware, the firmware itself (e2p file I found) and the Pinout too.
image
So I decided to try to flash, or at least to read the chip(interestingly) but in all manuals described firmware using PonyProg2000 and a homemade programmer.
Because home-made programmer I have, and make it not possible, but there are Arduino, interested in whether there is a possibility to carry out my task, and if there is something I would like to know in what direction to dig.
asked by | 101 views

2 Answers

0 like 0 dislike
It is likely the memory chip 24c04. The i2c interface. Write a program that reads/writes the bits. And send by UART. But I would not zamorachivatsya. The programmer for the com port — 2 resistor. Much easier and intuitive.
PS Samsung scx4200 also stitched
answered by
0 like 0 dislike
I tried that it sort of flashed, but haven't checked.
And in fact, will be more reliable that this
answered by
Welcome to Bug-code Q&A, where you can ask questions and receive answers from other members of the community.

24.8k questions

46.2k answers

0 comments

13.5k users

24,788 questions
46,220 answers
0 comments
13,471 users