Please enable / Bitte aktiviere JavaScript!
Veuillez activer / Por favor activa el Javascript![ ? ]
What might not work computer after Assembly? - bug-code.com Q&A

What might not work computer after Assembly?

0 like 0 dislike
14 views
Hello. Decided to upgrade the computer. To do this, bought a new processor, motherboard, RAM and CPU cooler.


Collected. When turning on no image on the monitor and the speaker isn't beeping, and the fans are buzzing.(The speaker works because when switched off, RAM it emits signals).


The power to the motherboard and processor hooked up. Graphics card and PSU on the old motherboard, CPU and RAM are working properly. Rechecked after a build failure new.

BIOS was reset, by removing battery for 10 minutes.

Some say that may snap a reset, I disconnected.

None of the above helped.


The configuration of the computer:

Power supply: FSP ATX-450N, 450w.

Motherboard: ASUS LGA1155 P8H61-M

CPU: Core i3-2120

Video card: Nvidia Geforce GT-440


Thank you. I hope for your help. The computer was collected not for the first time, but this the first time.
asked by | 14 views

7 Answers

0 like 0 dislike
The motherboard is dead or the BIOS contents flew (which is stored in flash. not CMOS). To drop CMOS a little is not enough to pull the battery on the motherboard to reset is a special jumper.
answered by
0 like 0 dislike
Zoink upgrade...
\r
To do this, bought a new processor, motherboard, RAM
Are you on a new computer hung old rest.
answered by
0 like 0 dislike
But if the video card to pull a video cable to plug into the motherboard, the image does not appear?
answered by
0 like 0 dislike
1. Right podsoedenit wire from the case to the motherboard?
2. Perhaps the PSU is weak. even for your graphics card. I have for example 450 W gf 8800 does not start. However the power supply was old and a little-known Chinese company
3. it is necessary to check the fastening of the graphics card, memory and CPU. To test the processor on the subject of broken legs (it happens)
answered by
0 like 0 dislike
-1. what notes makes the speaker?
\r
0. Until will not start — use only the built-in none, processor, cooler and memory.
\r
1. the jumper is usually called cmos, clrts, ccmos and other details look in the manual to the motherboard
looks like this image
just remove it from the provisions of the 0-1 and 1-2 in a place, move back
\r
2. a 12V supply is not forgot to connect (yellow-black square connector near the CPU)
\r
3. The power button or reset are not closed? disconnect all wires of the front panel and short the PWR_SW with a screwdriver to start
\r
4. If your processor is supported by motherboard? Maybe the BIOS is too old for this version of the processor to take over the old, update, Beavis, put your
\r
5. Go with a toothbrush on the motherboard... maybe somewhere something got
\r
6. Generally to get the mother out of the coffin and test all on the knee.
answered by
0 like 0 dislike
1 long, 2 short Failure in video system An error was encountered in the video BIOS ROM or a horizontal retrace failure has been encountered
\r
Food vidyuhi given? =)
Without a video card and memory as beeps?
answered by
0 like 0 dislike
Less than a week ago collected a new computer and too quiet and no image.
Cant found when you brought the iron to a service center...
\rWere bent one leg at the percent. Highly recommend carefully again to see. I have 2 times checked and noticed that only the guys in Garantie, right in front of me.
answered by
Welcome to Bug-code Q&A, where you can ask questions and receive answers from other members of the community.

24.8k questions

46.2k answers

0 comments

12.7k users

24,788 questions
46,220 answers
0 comments
12,694 users